Instruction Manual of Integrated Solar Street Light

Instruction Manual of Integrated Solar Street Light, All In One (AIO) Solar Street Light

Brief:
Our integrated solar street light which integrates the green-energy parts Solar Panel, LED Lamp and the Lithium
battery into a single product, with intelligence induction system to gain the solution of low-energy, long-time,
high-luminance and free maintenance. At the same time, it’s convenient in the shipment and installation.
Purpose:
To be installed in the garden, residential area, courtyard, road, mine area or parking area or provide the light in roads
where it’s necessary, the battery provide the energy for lighting, and the solar panel charge for the battery.
Product parts:
The product is made up with the integrated parts (Solar panel, Lithium Battery, LED, Intelligent Controller and
Intelligence Induction System), which can be installed on the pole or wall directly.
Working Characters:
The solar panel converts sunlight into electricity and stored in lithium battery via controller, the LED light will work at
night automatically by light sensor control, and provide lighting for the darkness area, the intelligence induction system can save the energy when the high-brightness lighting is not necessary.

Manual：

“All in One solar light” can not work without sunshine charging, please select the suitable product model according to the local sunshine radiation and the annual total radiation.
“All in One solar light” adopts the long-lifespan lithium battery for storing energy, charging temperature at day time is between: 0°C～+60°C, when temperature goes lower than 0°C, the control system will stop charging automatically to protect the battery, and it will revive to charge the battery while temperature goes higher than 0°C. Discharging temperature at night is between: -30°C～+70°C, any ambient beyond will bring damage to the battery. Please confirm your local extreme temperature is suitable for above while selecting the solar light.
Battery of the “All in One solar light” can be stored for 6 months after full charged, and please examine, charge it periodically after long time transportation to prevent damage.
While the solar light be installed in Northern Hemisphere, please make sure the surface of the solar panel to be facing the South to collect maximum sunshine radiation, While installed in Southern Hemisphere, please make sure the surface of the solar panel to be facing the North to collect maximum sunshine radiation. At the same time please keep it away from any shadow of house, trees etc.
Keep cleaning the surface of the All in One solar light with normal detergent to get maximum power generation, clear the dust or tree leaves or any grease.

Installation:

To place the light pole into the best spot with good day lighting. The height of light pole should be more than 3m, the thickness no less than 2.0mm with material iron or steel, the diameter recommend to be within the range of 50-110mm.

Install the lamp on the pole by its Support on the light, Clamps, Special screw and Second Support Brackets if any, steady installation should be ensured.

Please Charge All Model of light (without discharge at night) for 3 days before installing;

Please remove the plastic isolation film on the transparent lampshade if any before using;

Keep the device away from fire, water and moist places in order to avoid explosion, leakage, moisture;

Any severe shock or smash to the light is not recommended;

No one expect professional technician should attempt to disassemble to the light in order to avoid damaging the light.
This couplet considered as the Protection to fix warranty, so please reserve them carefully.